Twin Power Ignition Wire - 110118

V-Twin motorcycles are the heart and soul of Americas motorcycle industry. Theres no better way of showing the pride you put into your motorcycle than by using American made parts.
Twin Power ignition leads are 8.65 mm thick with 500 Ohms/ft. of resistance
The core of these leads are made with Kevlar reinforced by fiberglass strands for additional strength
Only mag wire is used to ensure conductivity and elimination of RFI (radio frequency interference) and noise suppression
The core is then covered by a layer of EPDM with a layer of braided tape for strength and flexibility
The outer jacket protecting the mag wire core is a high quality silicone to ensure heat resistance is maximized, extending the longevity of the wire set
Silicone distributor and spark plug boots are used to help dissipate
the heat
Stainless steel terminals are used to reduce potential corrosion
Each ignition lead is built with S' J2031 class E rated cable for heat protection of 4500F
Each wire set includes a packet of dielectric grease to prevent arcing, keep moisture out, and prevent corrosion
Each wire set includes two miniature cable ties
Made in USA