Product Information
Start any engine regardless of displacement or compression ratio with a stock starter
Save your starter and battery; tested for 10,000 starts without running battery down
Allow for easy start by initially reducing crank compression, but once the engine starts and rpm increases, the compression release lobe is centrifugally retracted and the engine runs normally, with full compression, and without any loss in performance
Available in chain drive and gear drive versions
All chain-drive cams include installation kit
All gear-drive cams include 4-gear set and installation kit
Gear-drive cams also available with inner gears only; intended for cam replacement for motors that have already been converted to an S&S gear-drive system
Made in the U.S.A.
NOTE: Installer must check coil bind, valve-to-valve clearance and valve-to-piston clearance.
NOTE: Due to the inherent characteristics of gear drives, you may experience more valve train noise.
High power cam for modified engines, increase compression, high lift springs and large bore throttle body required
For best results requires ported heads, low restriction intake/ exhaust
RPM range 4000-6500
